Xebec iTouchpad Diamond Series Wireless Keyboard Review

1. Introduction2. Xebec iTouchpad Diamond Series Wireless Keyboard3. Xebec iTouchpad (Super High Res Gallery)4. Performance and Closing Thoughts5. View All Pages

The keyboard is shipped in a diminutive package with a picture of the product on the front.

Inside, the keyboard is protected with a clear plastic cover. There is a USB cable for charging, two rechargeable batteries and literature on the product.

The keyboard measures 307.2 x 24.8 x 203.1 mm and weighs 657 grams with the batteries installed. The trackpad is placed underneath the main keyboard area and has two buttons, just like a dedicated mouse.

The keyboard is responsive and is based on soft touch membrane technology. It isn't a wonderful choice as a main typists keyboard, but considering it is designed for a media center and use on a chair or sofa, we wouldn't expect the target audience to be concerned.

There are a row of function keys along the top and the only thing missing is a num pad on the right of the board. This would have obviously made it much wider and less portable.

The rear of the board is black, and features two adjustable feet on either side, for height adjustment. They feel reasonably strong and should withstand moderate abuse. The company say these are ‘skid proof' which is a rather bizarre claim to make. They don't move under slight pressure, but they are just plastic.

When the product is shipped, the USB receiver is stowed away inside the keyboard for safety. There is also a power on/off switch next to this. On the right hand side, is a ‘pairing' switch so the keyboard can sync with the USB receiver. They should only need paired once.

The tiny USB receiver needs to be removed from the slot and then inserted into a free USB port on the target computer.

The two batteries (supplied), need to be inserted into the compartment as shown above. You can use ordinary batteries with this product, but be aware not to try and charge them with the USB cable supplied!

The USB cable which is supplied, simply plugs into the port at the very top of the board for charging. The power switch on the rear should be placed in the ‘on' position.

Top right of the keyboard section are three icons, next to individual blue LED lights. The lightning icon on the left is a pairing and transmitting LED which indicates that the keyboard and USB receiver are in pairing mode. This stops flashing after successful synchronisation. It also flashes when any key is pressed and when the track pad is in use.

The middle icon is the battery low LED which indicates when the batteries are below 2.2 volts. It is always on until a new set of batteries are inserted (or charged), or the battery is used up completely.

The icon on the right is a recharging LED which flashes when the batteries are recharging and are on permanently when the batteries have fully charged.

The keyboard has three modes of operation as detailed below.

• Sleep mode:
  when there is no input on the keyboard or touchpad for over 30 minutes the keyboard automatically turns into Sleep mode (idle state) to save battery power. in this mode the keyboard only consumes 30 uA of power.
• Wake up mode:
  To activate the keyboard from sleep mode, press any key on the keyboard (not the left or right mouse function key of the touchpad), or the touchpad itself. In standby mode the keyboard takes 14mA of power.
• Reconnect mode:
  The keyboard automatically connects to the USB receiver after it is reactivated. Depending on the environmental conditions the radio transmission to reconnect will take between 1 second and a few minutes. We never experienced anything longer than 5 seconds for reconnection during our test period over the last week. The keyboard takes 100 mA of power when fully active.

Become a Patron!